Englander Blue Ridge 100 Wood Stove (ESW0001)

A Small EPA-Certified Wood Stove Heating 250–1,200 Square Feet

The Englander Blue Ridge 100 heats 250–1,200 ft² with up to 45,000 BTU/h from a 1.8 ft³ firebox and includes a pedestal, ash lip, air intake damper, and rear air deflector.

Key Features

• Recommended heating area of 250–1,200 ft² with up to 45,000 BTU/h maximum heat output
• EPA 2020 certified non-catalytic combustion at 1.8 g/h particulate emissions
• 1.8 ft³ firebox accepting logs up to 17" (16" recommended) with up to 5 hours of burn time
• Deeper combustion-chamber bottom that allows greater ash accumulation between cleanouts
• Steel top reinforced with a stainless steel heat shield
• Cast iron door with ceramic glass and glass airwash system
• Included pedestal, ash lip, air intake damper, and rear air deflector
• Proudly made in USA and Canada

Product Features

Heating Performance for 250–1,200 Square Feet

Rated to heat 250 to 1,200 ft², the Blue Ridge 100 provides up to 45,000 BTU/h of maximum heat output from its 1.8 ft³ firebox, subject to installation and operating conditions.

EPA 2020 Certified Clean Combustion

This small non-catalytic stove is EPA 2020 approved with an average particulate emission rate of 1.8 g/h and uses a stainless steel secondary-air system to support more complete combustion.

Deep Chamber Bottom for Less Frequent Ash Removal

The bottom of the combustion chamber is deeper than other models in its category, allowing a greater accumulation of ashes so the stove can be emptied less frequently. Ash is removed through the door; the included pedestal does not contain an ash drawer.

Compact Firebox with Depth Loading

The 19 3/8" deep firebox loads logs over its depth, accepts logs up to 17" (16" recommended), and provides up to 5 hours of burn time under applicable operating conditions.

Cast Iron Door with Airwash System

The single cast iron framed door carries a 9 5/8" x 8 1/8" ceramic glass surface, kept clearer by the integrated glass airwash system.

Certified Installation Versatility

The Blue Ridge 100 is certified for alcove installation and for mobile homes when equipped with a fresh air intake, installed according to the manufacturer's instructions, and an optional blower can be added for increased air circulation.

Product Specifications

Appliance Performance

General Features

Dimensions and Weight

Venting and Chimney Requirements

Certifications and Installation

Minimum Clearances to Combustibles*

*The certification label on the appliance and the current installation manual supersede published dimensions and clearances. Always follow the manufacturer’s installation instructions and applicable local codes.

**Some appliances have been tested with a low ceiling; refer to the installation manual before setting up the unit.

Manufacturer Notes

• Recommended heating area and maximum burn time may vary with location in the home, chimney draft, heat loss factors, climate, fuel type, and other variables.
• Efficiency and emission figures are measured under the applicable certification test methods; see the owner’s manual for details.
• Any installation must be done according to the data and drawings detailed in the owner’s manual.

About the Manufacturer

Practical Wood Heating Since 1976

Englander wood stoves have been proudly made in the US since 1976, with a focus on simple, reliable, and robust heaters built for everyday wood heating.

Blue Ridge Design and Certification

Blue Ridge series wood stoves use non-catalytic combustion with stainless steel secondary-air systems and are certified by an accredited laboratory to the applicable United States and Canadian emissions and safety standards published for each model, including EPA 2020 requirements.

Manufacturing and Support

Englander publishes installation and operation manuals, appliance dimension drawings, and replacement-parts resources for each model, and supports owners through its customer service and dedicated technical support lines.